Pitts S1-SS Construction Gallery » 2010 » February 2010

Finally finishing the spar cap strips on the underside.	Underside splice box pdoublers glued on, and partially...	Me, drilling the corner block holes for the drag wires.	Simon, my middle one, was there to snap a rare pic of me...	Corner block hole - through the middle
Another one through the middle.	Another drag wire hole.	Drag wire hole - 1/8" above center line.	One of the drag wire bays. Three to go!	Attachment brackets installed on the top wing center...
Grooves to allow the flying wires to attach to the...	Grooves to allow the flying wires to attach to the...	Attachment brackets installed on the top wing center...	Trial fitting of the top wing onto the fuselage.	Trial fitting of the top wing onto the fuselage.
Trial fitting of the top wing onto the fuselage.	Carbon Fiber seat back from York Enterprises. (before...	Carbon Fiber seat back from York Enterprises. (before...	Cleaning up the lower wing.	Checking and tightening all the wires. Including split...
Lower right wing, starting the rigging and alignment for...	Lower right wing, starting the rigging and alignment for...	Lower right wing, starting the rigging and alignment for...	Lower right wing, starting the rigging and alignment for...	Top wing Crush plate example - front
Top wing Crush plate example - rear	I-Strut boxesv - top wing	Flying wires attach	Flying wires attach	Flying wires attach onto crush plate - upper front
Flying wires attach onto crush plate - upper rear	Flying wires attach onto crush plate - lower front	Flying wires attach onto crush plate - lower rear	I-Strut box - lower	Hinges
Lower wing attach - before front hole gets drilled	Lower wing attach - before front hole gets drilled	Lower wing attach - before front hole gets drilled	Flying wire attach - upper center

39 Images | Made with JAlbum & Chameleon | Help